Negate: Energy meters often provide absolute values and provide information about the energy direction in a separate bit. is replaced by - and : or * is replaced by _. The default is 300 baud for modes A, B, and C and 2400 baud for mode D, and 9600 baud for SML.Īll available OBIS codes which are read out from the device are created as channels.Īt every read out the channels are synchronized with the OBIS codes from the device.įollowing conversion from OBIS codes to channel ID is done: DTWONDER Smart WiFi Switch ESP32 Ethernet Relay Board Domoticz Home Assistant openHAB RS485 TCP UDP 4 Channel Timer IP Watchdog 1.Ethernet means just support. If set to AUTO, it will be negotiated with the meter.
#Smart timer openhab serial#
USB to serial converters often require a delay of up to 250ms after the ACK before changing baudrate (only relevant for 'C' mode) dev/ttyUSB0ĭefines at which interval the values of the meter device shall be readĬan be SML (PUSH mode), ABC (PULL) or D (PUSH) URL to use for playing notification sounds, e.g. The smartmeter thing requires the serial port where the meter device is connected and optionally an refresh interval. This binding supports only one Thing: meter # Discoveryĭiscovery is not available, as the binding only reads from serial ports. Sprinklers do need a configuration property id identifying the device, but the.
There is no user configuration related to sprinkler things. You have to enter valid credentials to your Orbit B-hyve account, and you can also set the refresh time in seconds for polling data from the Orbit cloud. This binding retrieves and reads SML messages (PUSH) and supports IEC 62056-21 modes A,B,C (PULL) and D (PUSH). The bridge thing requires a manual configuration.
0 kommentar(er)
